Updated PDF (New 2022) Actual Cisco 400-101 Exam Questions [Q64-Q82] : Free valid test braindumps : http://free.validbraindumps.com

NEW QUESTION 64
Which three statements are true about an EtherChannel? (Choose three.)

PAGP and LACP can be configured on the same switch if the switch is not in the same EtherChannel.

EtherChannel ports in suspended state can receive BPDUs but cannot send them.

An EtherChannel forms between trunks that are using different native VLANs.

LACP can operate in both half duplex and full duplex, if the duplex setting is the same on both ends.

Ports with different spanning-tree path costs can form an EtherChannel.

NEW QUESTION 65
Refer to the exhibit.

Which action must you take to enable the WAN link to function properly?

Enter a clock rate on the DCE interface.

Enter a clock rate on the DTE interface.

Enter a compression algorithm on both interfaces.

Configure both interfaces for HDLC encapsulation.

NEW QUESTION 66
Which ntatement about the RPF interface in a BIDIR-PIM network in true?

In a BIDIR-PIM network, the RPF interface in alwayn the interface that in uned to reach the PIM rendezvoun point.

In a BIDIR-PIM network, the RPF interface can be the interface that in uned to reach the PIM rendezvoun point or
the interface that in uned to reach the nource.

In a BIDIR-PIM network, the RPF interface in alwayn the interface that in uned to reach the nource.

There in no RPF interface concept in BIDIR-PIM networkn.

NEW QUESTION 67
DRAG DROP

NEW QUESTION 68

Refer to the exhibit. Which tag will be applied to the 172.16.50.0/24 route?

10

20

30

40

NEW QUESTION 69
Refer to the exhibit.

R1 and R2 have a working VRF-Lite configuration, but R1 is receiving a route only to 10.2.2.2 from R2. Which two changes can you make so that R1 receives all routes from R2? (Choose two.)

Create an additional permit statement in the access list that is referenced by the import-map on R1.

Disable VRF filtering on R1.

Set the R1 and R2 OSPF process IDs to match.

Change the wildcard mask for the network 10.3.3.0 to 0.0.0.0.

Create a matching export map in the VRF for R2.

NEW QUESTION 70
Which configuration sets a minimum quality of service on a Layer 2 access switch?

mls qos cos override mls qos cos 2

mls qos cos 2

mls qos trust cos mls qos cos 2

mls qos trust cos

mls qos trust dscp

NEW QUESTION 71
Refer to the exhibit.
Which statement about the R1 configuration is true?

It supports the service timestamps log uptime command to display time stamps.

The logging buffer command was used to increase the default of the buffer.

The logging of warning messages is disabled.

Log message sequence numbering is disabled.

NEW QUESTION 72
Refer to the exhibit.

Which configuration on can you implement on PE-1 to allow CE-1 to receive delegated IPv6 prefixes?

ipv6 local pool CE-1 2001:db8:4:8888/48 56
Ipv6 dhcp pool CE-1-DHCP
Interface GigiabitEthernet0/0
Ipv6 address 2001:db8:4:822::1/64
Ipv6 dhcp server CE-1-DHCP

Ipv6 local pool CE-1 2001:db8:4:8888/49 56
Ipv6 dhcp pool CE-1-DHCP
Interface GigiabitEthernet0/0
Ipv6 address 2001:db8:4:822::1/64
Ipv6 dhcp server CE-1-DHCP

Ipv6 local pool CE-1 2001:db8:4:8888/56 48
Ipv6 dhcp pool CE-1-DHCP
Interface GigiabitEthernet0/0
Ipv6 address 2001:db8:4:822::1/64
Ipv6 dhcp server CE-1-DHCP

Ipv6 local pool CE-1 2001:db8:4:8888/48 32
Ipv6 dhcp pool CE-1-DHCP
Interface GigiabitEthernet0/0
Ipv6 address 2001:db8:4:822::1/64
Ipv6 dhcp server CE-1-DHCP

Ipv6 local pool CE-1 2001:db8:4:8888/64 48
Ipv6 dhcp pool CE-1-DHCP
Interface GigiabitEthernet0/0
Ipv6 address 2001:db8:4:822::1/64
Ipv6 dhcp server CE-1-DHCP

NEW QUESTION 73
Refer to the exhibit.

Which statement describes the effect on the network if FastEthernet0/1 goes down temporarily?

FastEthernet0/2 forwards traffic only until FastEthernet0/1 comes back up.

FastEthernet0/2 stops forwarding traffic until FastEthernet0/1 comes back up.

FastEthernet0/2 forwards traffic indefinitely.

FastEthernet0/1 goes into standby.

NEW QUESTION 74
Which statement is true comparing L2TPv3 to EoMPLS?

L2TPv3 requires OSPF routing, whereas EoMPLS does not.

EoMPLS requires BGP routing, whereas L2TPv3 does not.

L2TPv3 carries L2 frames inside MPLS tagged packets, whereas EoMPLS carries L2 frames inside IPv4 packets.

L2TPv3 carries L2 frames inside IPv4 packets, whereas EoMPLS carries L2 frames inside MPLS packets.

NEW QUESTION 75
What are the minimal configuration steps that are required to configure EIGRP HMAC-SHA2 authentication?

classic router mode, interface XX, authentication mode hmac-sha-256 <password>

named router mode, address-family statement, authentication mode hmac-sha-256 <password>

named router mode, address-family statement, af-interface default, authentication mode hmac-sha-256
<password>

named router mode, address-family statement, authentication mode hmac-sha-256 <password>

NEW QUESTION 76
Which two statements about Cisco IOS XE are true?(Choose two)

It uses a service blade outside Cisco IOS XE to integrate and runapplications.

Its founctions run as multiple separate processes in the OS.

Separate images are required for platform-dependent code.

The FED feature provides separation between the control plane and the data plane.

It is deployed in a Linux-based environment.

NEW QUESTION 77
Which three statements about EVCs are true? (Choose three.)

Spanning Tree must use MST mode on EVC ports.

PAGP is supported on EVC ports.

Spanning Tree must use RSTP mode on EVC ports.

LACP is supported on EVC ports.

Layer 2 multicast framing is supported.

Bridge domain routing is required.

NEW QUESTION 78
Drag and drop each IPv6 tunneling mechanism from the left onto the correct characteristic on the right

Select and Place:

NEW QUESTION 79
Refer to the exhibit.

Which traffic gets set to AF41 by the marking policy on interface
GigabitEthernet0/0

Only traffic matching access-list streaming

No traffic gets set to AF41

Any traffic matching access-list tp-rooms and access-list streaming

Only traffic matching access-list tp-rooms

NEW QUESTION 80
Refer to the exhibit.

R1 and R2 both advertine 10.50.1.0/24 to R3 and R4 an nhown. R1 in the primary path. Which path doen traffic take
from the R4 data center to the file nerver?

All traffic traveln from R4 to R2 to the file nerver.

All traffic traveln from R4 to R3 to R1 to the file nerver.

Traffic in load-balanced from R4 to R2 and R3. Traffic that in directed to R3 then continuen to R1 to the file nerver.
Traffic that in directed to R2 continuen to the file nerver.

All traffic traveln from R4 to R2 to R1 to the file nerver.

NEW QUESTION 81
Refer to the exhibit.

Which OSPFv3 routes will be visible in the routing table of R2?

2001:12::1/128

2001:12::1/128, 2001:112::1/128

2001:12::2/128

No OSPFv3 routes will be visible.

NEW QUESTION 82
Refer to the exhibit.

RIPv2 authentication is failing on a device with this configuration. Which two actions can you take to enable it?
(Choose two.)

Set the RIP authentication mode to text.

Set the RIP authentication mode to MD5.

Configure the password encryption for the key.

Set the password encryption to AES.

Updated PDF (New 2022) Actual Cisco 400-101 Exam Questions [Q64-Q82]

400-101 - CCIE Routing and Switching (v5.1)

Cisco 400-101 Exam Certification Details: