NEW QUESTION 38
A Client makes the request displayed below to the application server.
Which virtual server type should an LTM Specialist use to load balance based on the URI?
.

NEW QUESTION 39
An LTM Specialist must create a new virtual server for HTTP access. The LTM Specialist creates a forwarding virtual server to reach the resource.
What is a potential result of this action?

NEW QUESTION 40
An LTM Specialist needs to apply SNAT using currently used SNAT pool to a new virtual server.
What needs to be completed before applying that configuration change?

NEW QUESTION 41
An LTM Specialist is removing some of the load off an existing cluster by adding a adding a third BIG-IP device to the device group. The new device can deliver twice the performance of the other two devices.
The LTM Specialist needs to make sure that the BIG-IP device with the highest available capacity is always selected to take over a traffic group in the event of a failover.
Which failover method is most appropriate?

NEW QUESTION 42
An application is making heavy use of a large, high-quality JPEG image file. An LTM Specialist needs to enhance page load times without increasing server load.
Which profile should be applied to the virtual server to perform this task?

NEW QUESTION 43
What should an LTM Specialist configure on an LTM device to send AVR notification emails?

NEW QUESTION 44
A node is assigned two monitors as seen in this configuration.

What is the status of a member that runs on that node and listens on port 443?

NEW QUESTION 45
A web application is configured as follows:

What should be modified to set a maximum request limit?

NEW QUESTION 46
Refer to the exhibit.

The LTM devices LTM3 and LTM2 have four Traffic Groups defined with approximately the sar of failover objects defined in each group.
– Traffic Groups A and C have Default Device set to LTM1
– Traffic Groups Band D have Default Device set to LTM2.
– Traffic Groups B and C do NOT have Auto Failback enabled. Traffic Groups A and D have Auto Failback enabled with a timeout value of 60 seconds.
– Traffic Groups A and D have Auto Fallback enabled with a timeout value of 60 seconds.
Both LTM devices are healthy and able to pass traffic for any Traffic Group.
LTM1 loses connectivity on interface 1.4. The LTM Specialists notified 60 seconds after the interface goes down.
What is the state of the Traffic Groups on each LTM device?

NEW QUESTION 47
An TLM Specialist needs to configure a virtual server to terminate SSL connection on the LTM device.
Cryptographic information must be re-authorized for SSL sessions that remain open for longer than 30 seconds.
Which settings should the LTM Specialist configure in the client SSL profile?

NEW QUESTION 48
A LTM device needs to load balance active and passive FTP traffic while using only a single virtual server.
Which virtual server type should an LTM Specialist configure on the LTM device?

NEW QUESTION 49
A custom TCP application using a single server is being migrated to the LTM device. A server is being added to the pool. The application is known to violate the TCP protocol RFC. The application currently works without error from a user perspective.
Which virtual server type is appropriate in this situation?

NEW QUESTION 50
An LTM Specialist decides to offload SSL traffic on the LTM device instead of just passing it through. The LTM Specialist needs to change the configure from a Performance (Layer 40 virtual server to a Standard virtual server with SSL offload.
Which two element the LTM Specialist consider when performance this task? (Choose two.)

NEW QUESTION 51
A pool has four members. Ail of the servers have been designed and configured with the same application. Each client’s request can significantly the performance of the servers.
Which load balancing method should the LTM Specialist use to maintain a relatively even load across all servers?

NEW QUESTION 52
An LTM Specialist observes decreased performance and intermittent connection reap LTM system.

Based on the configuration, which action will address these issues?