QUESTION 38
Steel shot grit contaminated with oil or grease used in a cetrifugal blast cleaning should be

QUESTION 39
Differences in technique for abrasive blasting concrete versus steel require the operator to:

QUESTION 40
NACE Standards include:

QUESTION 41
Which product, when closely inspected has a green or red layer of fusion bonded epoxy (FBE) that is visible directly on the steel?

QUESTION 42
Inspector reports should always be copied to:

QUESTION 43
Centrifugal blast cleaning requires:

QUESTION 44
You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

QUESTION 45
Non-Conformance Reports are designed to:

QUESTION 46
When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:

QUESTION 47
When working with someone who is very concerned about Stability and maintaining adherence to the status-quo, the Inspector should try to:

QUESTION 48
Antifouling coatings are regulated by international treaties.

QUESTION 49
Linings are used on the interior of pipelines to

QUESTION 50
You are NACE Level 2 Inspector working on a tank lining job where a mobile centrifugal blast unit is being used to blast the tank floor to a NACE No.1/SSPC SP 5. The Contractor has completed his final blast and has called for a hold point inspection. This is the 1 st time you have seen field based centrifugal blast cleaning. You observe what appears to be staining on the substrate however the Contractor assures you this is normal when using centrifugal blast units and what you are seeing is what is defined in the standard as an acceptable variation in appearance.
Your FIRST preferred course of action is to:

QUESTION 51
Which standards are generally established by private-sector bodies and are available for use by any person or Organization, private or government?

QUESTION 52
You are the NACE Level 2 Inspector with the final responsibility to prepare the final report for a very large structural steel shop project which has gone very well. It is due next week. The work has been ongoing for two years and several NACE Level 1 Inspectors have worked under your supervision throughout the project. You find you are missing one week of daily reports for the night shift from the very beginning of the project and despite your best efforts they are cannot found.
You FIRST preferred course of action is to:

QUESTION 53
When observing design defects the NACE Inspector should:

QUESTION 54
Which concrete smoothing technique involves scrubbing a mixture of cement mortar over the concrete surface using ai cement sack, gunny sack, or sponge rubber float?

QUESTION 55
You have just your NACE CIP Level 2 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

QUESTION 56
All of these are advantages of using repair patches EXCEPT

QUESTION 57
The main reason dehumidification is used during coating operations is to

QUESTION 58
Measuring methyl ethyl ketone (MEK) resistance of ethyl silicate inorganic zinc-rich primers by solvent rub requires

QUESTION 59
The number of air turns in an enclosure can be affected by all of these EXCEPT

QUESTION 60
In powder coatings, when the particles of powder begin to flow but are not fully liquid, they are in what stage?