Released Nutanix NCM-MCI-5.20 Updated Questions PDF [Q40-Q58]

Rate this post

Released Nutanix NCM-MCI-5.20 Updated Questions PDF

NCM-MCI-5.20 Dumps and Practice Test (166 Exam Questions)

Successful completion of the Nutanix NCM-MCI-5.20 certification exam demonstrates that a candidate has the knowledge and skills required to deploy, manage, and operate Nutanix solutions for multicloud infrastructures. Nutanix Certified Master – Multicloud Infrastructure (NCM-MCI) 5.20 certification is highly regarded in the IT industry and can lead to increased job opportunities and higher salaries for IT professionals.

NEW QUESTION 40
Refer to the exhibit.

An administrator creates a security policy that isolates their financial application from accessing the Internet When viewing the policy in Prism Central, several connections from the application are outbound to the Internet.
What is causing this issue with the policy?

The 0.0.0.0 address was not specified in the outbound rule.

The blocked connections are illustrated for information only.

The Activate box was not checked in the rule, so it is not enforcing.

The policy has been left in monitor mode instead of enforcing mode.

NEW QUESTION 41
In an AHV cluster, an administrator needs to enable an application to share a disk b group but needs to enable the VMs to see the volume group.
How should the administrator accomplish this task?

Configure a virtual disk on each VM with identical attributes in the storage dashboard.

Add the volume group to the VM using the update link from the VM dashboard.

Add a disk to one VM and enable read/write on it from the other VM.

Create a shared folder for the VMs using Nutanix Files.

NEW QUESTION 42
An administrator reviews the error in the exhibit, the examines the state of the cluster, the administrator finds that the AHV host is up and Functional , but the cluster capacity is low.
What will happen to the VMs on the host with this controller VM?

They will remain on the current host

they will reboot onto other nodes in the cluster

the will shutdown and be orphaned on the host

they will be shutdown unless protected by a Protection Policy

NEW QUESTION 43
An administrator receives an alert in Prism indicating that interface eth2, on an AHV host is receiving many CRC errors. After togging into the problematic host, the following command is run to show the indicated output:

What is causing this issue?

Incorrect link speeds on the switch

The interface is incorrectly configured with Jumbo Frames

A misconfigured bond

A physical layer network problem

NEW QUESTION 44
An administrator is deploying several new application VMs to a Nutanix cluster. The application is very transactional with a 28/72 random, read/write ratio.
What should the administrator do?

Add a minimum of four SSDs to each node to ensure all writes go to the SSDs.

Add a minimum of four virtual disks to each VM, and aggregate them on guest OS level.

Add one large SSD to each node and enable Flash Mode for the VMs.

Add one large virtual disk to each VM. and use it for all application data.

NEW QUESTION 45
A customer has the following requirement for a Nutanix cluster:
Must support high-performance Nutanix Volumes iSCSI workloads
Must utilize AHV nodes
Must use 10 GbE interface
How should the customer optimize networking?

Enable Jumbo Frame on just the Host

Convert Cluster to ESXi and enable Jumbo Frame on Host and CVM

Enable Jumbo Frames on just the CVM

Enable the use of Jumbo Frame on Host and CVM

NEW QUESTION 46
An administrator is notified that a bare metal database server is down. This database server is being served storage using a Nutanix Volume Group. Upon investigating, the administrator finds that the disks in the database server that map to the vDisks in the volume group have gone offline.
What is causing this issue?

The Volume Group Load Balancer has been disabled.

Port 9443 is blocked in the server firewall.

Port 3260 has been blocked in the server firewall.

A CVM serving the Volume Group has gone offline.

NEW QUESTION 47
An administrator receives a notification that storage in a Nutanix cluster is unavailable. The cluster consists of five nodes and is configured with a Fault-Tolerance level of 1 (FT-1).
Upon investigation, the administrator finds the following:
* All AHV hosts are powered on and the CVMs are running
* Nodes A, B, and C are connected to one top of rack switch
* Nodes D and E are connected to a second top of rack switch
* The cluster status command run on Node A shows that CVM services on nodes D and E are down Which issue is causing the storage outage?

The default gateway for the CVMs and AHV hosts is down.

The switch connecting Nodes D and E is down.

The genesis process is down on both Nodes D and E.

Nodes D and E are in maintenance mode.

NEW QUESTION 48
Which two CVM components are used to provide data Locality? Choose 2

Volume Group

Logical unit

Unified Cache

Extent Store

NEW QUESTION 49
Which statement best defines Replication factor 2 (RF2 ) ?

Data Will be written locally, and a second copy to another disk group

Data will be written locally, and a second copy goes to another node in the same cluster

data will be written locally and a second copy then will be replicated to another cluster

Data will be written locally, and a second copy goes to a remote site.

NEW QUESTION 50
An application owner had reported that an AHV – based critical application VM is performing very slowly, after initial diagnostics is has been observed that the CPU utilization is significantly higher than normal.
What two actions should the administrator take on this VM without shutting it down? choose two.

increase the number of vCPU in prism element

use prism element to increase the number of cores

configure additional cores in acli

ensure CPU Hot-add is supported by the Guest OS

NEW QUESTION 51
An administrator has a custom backup application that requires a 2TB disk and runs in Windows. Throughput is considerably lower than expected.
The application was installed on a VM with the following configuration:
* Four vCPUs with one core/vCPU
* 4GB of Memory
* One 50GB vDisk for the Windows installation
* One 2TB vDisk for the application
What is the recommended configuration change to improve throughput?

Increase the number of cores per vCPU

Increase the vCPUs assigned to the VM

Span the 2TB disk across four vDisks

Add 4GB of memory to the VM

NEW QUESTION 52
An administrator needs to maximize storage potential in a six-node cluster. The container is configured with the following:
Post-process compression
Capacity deduplication
What should the administrator configure to increase space savings?

Erasure coding

Inline compression

Reserve capacity

Cache dedupe

NEW QUESTION 53
An administrator recently added in 3 nodes to an existing 5 node cluster. While 1 node came with its own block, the other 2 nodes where added to an existing share. After adding the nodes, the administrator sees that the hardware tab displays the correct number of nodes, but incorrect position in the diagram tab.
What should the administrator do to resolve the issue?

Check the factory_config.json for all 3 nodes

SSH into CVM and perform genesis restart on each CVM

SSH into the CVMs and run genesis acropolis stop; cluster start

Check the factory_config. json for the two single nodes.

NEW QUESTION 54
A CEO asks the IT administrator to provide a list of required resources to protect current workloads and the two new SQL servers from a disaster. The Nutanix environment is managed by Prism Central.
Which option explains how to meet the CEO’s request?

In Capacity Runway, select Optimize Resources and select all VMs that must be protected.

Create a new project and assign the VMs to it to get compute and storage requirements.

Create a new scenario based on a new cluster based on a VM Profile and select Recommend.

Create a new Recovery policy by selecting the VM that needs to be protected and get hardware requirements.

NEW QUESTION 55
An administrator is updating disk firmware using LCM and receives the following message:
“there have been 10 or more cluster services restarts within 15 minutes in the Controller VM” The message appears as each drive is upgraded.
What is the reason this message is being generated?

A node has been rebalanced

A drive has been reformatted

A node has been rebooted

A drive has been ejected

NEW QUESTION 56
An administrator manages the following two Nutanix AOS 5.15 cluster environment:
* Corp-cluster-01
* Corp-cluster-02
The VM images must be available only on Corp-cluster-01, but cannot be checked out to cluster Corp-cluster-02. The images also cannot be checked out to any other clusters that are registered with Prism Central in the future.
Which two configuration settings must the administrator choose when creating the image placement policy that satisfies the stated requirements? (Choose two.)

Create an image placement policy that identifies cluster Corp-cluster-01 as the target cluster

Set the policy enforcement to Soft.

Set the policy enforcement to Hard.

Create an image placement policy that identifies cluster Corp-cluster-02 as the target cluster.

NEW QUESTION 57
An administrator of a Nutanix Enterprise Cloud has microsegmentation enabled and a firewall VM installed. The security team notifies the administrator that one of the VMs hosted in the environment has been exhibiting suspect network activity. The administrator wants to isolate the VM from the production network, but must still be able to access it to perform diagnostics.
What should the administrator do to meet the requirement?

Disable the vNIC on the affected VM

Quarantine the VM using the Forensic Method

Create a firewall rule that blocks VM traffic but permits diagnostic access

Create a security policy with a service chain directing that VMs traffic to the firewall VM

NEW QUESTION 58
An administrator is monitoring the Nutanix v5.15-based AOS cluster performance logs and notices that a SQL server VM is greatly exceeding its intended maximum IOPS. The administrator has confirmed that a QoS policy was previously created for the group of VMs this server is a member of.
What are two reasons that this VM would exceed its maximum configured IOPS from the QoS Policy? (Choose two.)

The VM is missing the required snapshot needed to implement the QoS Policy.

The VM was not created as an AFS virtual machine.

The SQL Server VM has volume groups attached.

It was cloned from another SQL Server VM that was a member of the QoS Policy.

The NCM-MCI-5.20 exam covers a wide range of topics, including Nutanix hybrid and multicloud solutions, automation and orchestration, security and compliance, and disaster recovery. Additionally, the exam evaluates the candidate’s ability to design and deploy Nutanix clusters, manage data storage and protection, and troubleshoot common issues that arise in a multicloud environment.

NCM-MCI-5.20 Exam Dumps Pass with Updated 2024 Certified Exam Questions: https://www.validbraindumps.com/NCM-MCI-5.20-exam-prep.html