NEW QUESTION 19
Is this part of the process for using NetEdit to update firmware on ArubaOS-CX switches?
Solution: Use a firmware update plan to manage both updating the Image on selected devices and reboot.

NEW QUESTION 20
Is this a rule for configuring schedule profiles on an ArubaOS-CX switch?
Solution: With the exception of a single strict priority queue, all queues must use the same scheduling algorithm.

NEW QUESTION 21
Refer to the exhibits. Is this how the switch-1 handles the traffic?


Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN 10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.3, out not 192.168.1.2.

NEW QUESTION 22
Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: to help the switch to look inside tunneled traffic and apply different quality of service (QoS) settings to different types of traffic

NEW QUESTION 23
Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: IPv6 protocol can be encapsulated in the underlay network’s IPv4 packets.

NEW QUESTION 24
You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The guard interval is set in units of 10 ms and should exceed the maximum expected delay for forwarding a frame around the complete ring.

NEW QUESTION 25
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: You are not concerned about split Drain Issues in your environment, so you want the secondary member to keep its links up if the ISL falls.

NEW QUESTION 26
Does this correctly describe routing information advertised by a VXLAN Tunnel Endpoint (VTEP) that uses EVPN?
Solution: MAC/IP advertisement routes advertise the MAC addresses that can be reached through the VTEP.

NEW QUESTION 27
Does this correctly describe NetEdit’s notification capabilities?
Solution: NetEdlt can send an error link to admins through ServlceNow.

NEW QUESTION 28
Refer to the exhibit. Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?

Solution: To force the router to use both links, ensure that active gateway is enabled on LAG 100 on both Switch-1 and Switch-2.

NEW QUESTION 29
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: In situations in which the primary switch fails and then reboots, you want to make the primary switch take over again as the primary switch.

NEW QUESTION 30
Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer (AFC) is integrated with Nutanix?
Solution: Automated configuration of Layer 3 MP-BGP protocol on leaf switches

NEW QUESTION 31
Is this a difference between a typical data center network’s requirements and a typical campus network’s requirements?
Solution: Data center network traffic flows are typically east-west whereas while campus networks experience more north-south traffic.

NEW QUESTION 32
Is this a way that Virtual Switching Extension (VSX) differs from Virtual Switching Framework (VSF)?
Solution: VSX is recommended for the access layer of data centers and campuses while VSF is recommended for the core.

NEW QUESTION 33
Is this a best practice when positioning ArubaOS-CX switches in data center networks?
Solution: Deploy Aruba CX 83xx switches as data center spine switches.

NEW QUESTION 34
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Implement Virtual Switching Extension (VSX) on pairs of ERPS switches at the same site. Then combine multiple links between two data centers into VSX LAGs (M-LAGs).

NEW QUESTION 35
Refer to the exhibit.

The company wants AtubaOS-CX switches to provide VXLAN services for several VMs and servers, as shown in the exhibit. Hypervisors will not run VXLAN for this solution. Is this part of a valid configuration to meet the requirements?
Solution: Attach VNIs 5010 and 5020 to interface 1/1/3 on Switch-2.

NEW QUESTION 36
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Inside a configuration plan, right-click any device-specific parameters and modify the parameter per-device.

NEW QUESTION 37
Can you attach this type of ArubaOS-CX interface to a VRF?
Solution: A loopback interface

NEW QUESTION 38
Two ArubaOS-CX switches ate part of a Virtual Switching Extension (V5X) fabric. Is this a guideline for configuring the switches’ link-up delay settings?
Solution: Set the link-up delay timer based on the number of MAC forwarding, ARP, and routing table entries.

NEW QUESTION 39
Is this how you should position switches in the ArubaOS-CX portfolio for data center networks?
Solution: Deploy Aruba 8400 switches as data center leaf switches.